Alkane Toolkit

Actions

Right-click one or more selected miners for the actions menu. With several miners selected, labels show the count, for example Restart (12). An action appears only when every selected miner's firmware supports it, so the menu changes with the selection.

Action What it does Changes the miner
Open in browser opens each miner's web page no
Refresh re-reads just these miners no
Check access (auth) tests whether the saved login is accepted no
View log (API)... shows the first selected miner's log (WhatsMiner: its active fault codes) no
Restore to stock firmware... removes aftermarket firmware; see Restore to stock yes, reboots
Flash lights / Stop flashing lights locate light on or off yes, harmless
Pause mining / Resume mining stop or start hashing yes
Set tuning %... tuning level, 0 to 100 yes
Set power target... power target in watts; the prompt shows the current value and the allowed range yes
Set hashrate target... hashrate target in TH/s, for firmware that tunes by hashrate yes
Set profile... pick a firmware profile or preset (only profiles every selected miner has are listed) yes
Restart reboot yes
Configure pools... set up to three pools yes
Set timezone... IANA time zone, for example America/Edmonton yes
Change password... new web/API password yes
Factory reset... wipes pools, tuning and network settings and reboots; the miner may come back on a new DHCP address yes, destructive

Safety

  • Pause, Resume, Restart and Factory reset ask for confirmation. Value prompts (tuning, targets, timezone, password) apply when you confirm the value.
  • Actions that change miners do not start while a scan is running, including an automatic rescan. Wait for it to finish or press Pause. Scans in turn wait for running actions.
  • Each changed miner is re-read automatically when the action finishes. Results and failures appear in the bottom-right corner of the status bar and in Settings > Logs.
  • If Change password succeeds on every selected miner, the saved global login is updated to the new password. If only some succeed, the saved login is left alone and the log says so.

Configuring pools

The pool dialog has three rows: Address, Account, Worker and Password. A row is used only when it has an address and an account. A blank password becomes x. The miner's username becomes account.worker.

Each field has a + menu with common pool addresses and the values you saved before (Add new... edits that list). Worker names can use placeholders that are filled in per miner:

Placeholder Becomes
{ip1} to {ip4} one octet of the miner's IP
{serial}, {mac} serial number; MAC without colons
{hostname} the miner's hostname
{brand}, {model}, {submodel} make and model
{firmware}, {cpu}, {cb} firmware family, control-board CPU and board
{nameplate-hr} the model's rated hashrate

For example, rack3-{ip3}-{ip4} gives rack3-1-50 for 10.0.1.50.