The saradc -22 was regulator_get_voltage on a dummy vref (no vref-supply in
DT), not the clk divider. Added vcc_1v8 fixed 1.8V regulator + vref-supply
(matching the vendor 86-panel). iio:device0 now reads both channels
(in_voltage0_raw=1023, in_voltage1_raw=246) — the adc-keys path works.
Five drivers verified this run: wifi, TRNG, OTP, GMAC, SARADC.
adc/SARADC-FIX.md; DRIVER-PARITY updated.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017wB8KB3MMQztRDXCMCkPrf
usb2phy: ported the RV1106 inno-usb2 phy config to 6.18 (rv1106_usb2phy_cfg;
fields map 1:1 except utmi_iddig->utmi_id and chg_mode->opmode; 5.10-only
iddig_output/en/bvalid_grf_sel dropped; phy_tuning left off, guarded so safe).
With PHY_ROCKCHIP_INNO_USB2=y + the u2phy/usbdrd/dwc3 DT enabled, verified on
warden-c8a3: the DWC3 comes up as xhci-hcd @ 0xffb00000 — USB host works. eth0
gadget just needs dr_mode=peripheral.
saradc: added rv1106_saradc_data (2-ch v2, matches the vendor) + the native
compatible. Driver now matches; probe still returns -22 (a clk-rate/setup detail,
not the data) — TODO.
Also captured: the growing board dts (USB nodes), the port fragments under usb/
and adc/. DRIVER-PARITY.md updated: ~14 drivers now at parity on 6.18.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017wB8KB3MMQztRDXCMCkPrf
