BFE EngineeringandClaude Opus 4.8
7e76553bd7
MAILBOX (fully open A7<->RISC-V SCR1 round-trip, 5/5 exact echoes on c8a3):
- rockchip-mailbox.c: rv1106 has 1 shared IRQ, not 4/channel -> added
rv1106_drv_data{num_chans=1} + compatible (rk3368 fallback assumed 4 -> probe
failed 'IRQ index 1 not found').
- clk-rv1106.c: CLK_CORE_MCU (SCR1 core clock) marked CLK_IGNORE_UNUSED -
6.18's clk_disable_unused() was switching off the coprocessor clock so a
loaded firmware never ran (5.10 left it on).
- Open SCR1 echo firmware (scr1-echo/, 154B RV32IMC) + load/test scripts;
A2B_INTEN on the MCU side + CMD-then-DAT (DAT=doorbell) order. Loaded via the
proven hpmcu.rs SRAM path; do NOT kill warden-flared (dw-wdt). mailbox/VERIFIED.md.
NPU (open GPL rknpu 0.9.2 kernel driver on 6.18):
- DT fix: base npu node lacks interrupt-names, driver requests IRQ byname
'npu_irq' -> probe bailed -ENXIO. Added interrupt-names='npu_irq'.
- Verified: [drm] Initialized rknpu 0.9.2 on minor 1; /dev/dri/card1;
rknpu_version_test PASS (0.9.2 + hw version, full power/clock/reset path).
- Honest ceiling: open compute (regcmd compiler) is a from-scratch ~person-year
RE project, no RV1106 prior art; ship the driver, no blob. npu/VERIFIED.md.
DRIVER-PARITY + CAPABILITIES-AUDIT updated; dts snapshot refreshed.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017wB8KB3MMQztRDXCMCkPrf
4.1 KiB
4.1 KiB
RV1106 6.18 driver parity vs the 5.10 vendor kernel
Goal: every driver the panel's 5.10 kernel runs must work at ≥ parity on our
self-built 6.18. Source of truth = the running 5.10 system on warden-c8a3
(lsmod + /proc/interrupts, captured 2026-08-24). Verify each on hardware via
the A/B _b-slot loop (../docs/m2-boot-on-c8a3.md); ✅ means confirmed on
c8a3, not just compiled.
| Driver / node | 5.10 evidence | mainline? | 6.18 status |
|---|---|---|---|
| CRU clock (clk-rv1106) | — | ported | ✅ M2 |
| pinctrl-rockchip (rv1106) | — | ported | ✅ M2 |
| GIC-400 / arch_timer | arch_timer | mainline | ✅ M2 |
| dw_mmc (eMMC) | dw-mci | mainline | ✅ M3 |
| 8250 uart2 (console) | ttyS2 | mainline | ✅ M2 |
| GPIO (rockchip, ×5 banks) | gpio-rockchip | mainline | ✅ batch1 (chips 0–4) |
| DMA (pl330, ff420000) | ff420000.dma-controller | mainline | ✅ batch1 |
| uart1 / uart4 | ttyS1, ttyS4 | mainline | ✅ batch1 |
| I2C (dw-apb, ff460000=i2c3) | ff460000.i2c | mainline | ✅ batch1 (i2c-3) |
| watchdog (dw-wdt, ff5a0000) | ff5a0000.watchdog | mainline | ✅ batch1 (watchdog0) |
| tsadc thermal (ff3c8000) | rockchip_thermal | ported (data+init+macros) | ✅ soc-thermal reads 39.8°C |
| SARADC (ff3c0000) | ff3c0000.saradc | ported (2-ch v2 data) | ✅ iio:device0 reads 2ch (adc-keys); fixed -22 via vref-supply |
| TRNG (rng@ff448000) | rockchip,trngv1 | mainline (rk3588 IP) | ✅ /dev/hwrng, real entropy (rng-otp/) |
| OTP/nvmem (ff3d0000) | rockchip,rv1106-otp | ported (px30_otp_read) | ✅ rockchip-otp0, reads chip id |
| GMAC (ffa80000) | rockchip,rv1106-gmac | ported (dwmac-rk rv1106_ops) | ✅ eth0 Link Up 100M/Full (gmac/) |
| GPIO_SYSFS (legacy /sys/class/gpio) | — | mainline (config) | ⬜ goodix script needs it |
| PWM (rockchip) | — | mainline (=m) | ⬜ batch2 =y (backlight) |
| RTC (rv1106-rtc) | — | ported (vendor driver) | ✅ /dev/rtc0 registers + reads |
| USB2 phy (inno, rv1106) | rockchip_usb2phy_* | ported (data, no tuning) | ✅ probes → USB up |
| USB host (DWC3→xhci, ffb00000) | xhci-hcd:usb1 | mainline | ✅ xhci host registered |
| USB OTG gadget (DWC3, eth0) | eth0 | mainline dwc3 | 🔨 host works; eth0 needs dr_mode=peripheral |
| crypto (aes/ccm/ctr/arc4) | modules | mainline | ⬜ batch2 (config =y) |
| PSCI node (removed) | — | — | ✅ deleted (no secure monitor → SMC fault) |
| VOP display (ff990000) | ff990000.vop | ported (rv1126 sibling) | 🔨 binds+DRM+card0; connector WIP |
| PWM backlight (pwm1) | — | mainline (rk3328 fallback) | ✅ backlight up (brightness) |
| RGB666 720×720 panel | — | panel-dpi | 🔨 probes; bus_format + connector WIP |
| GT911 touch (goodix) | goodix, gt911 | mainline | ⬜ M4 (needs GPIO_SYSFS ✅ + node) |
| GPIO_SYSFS / crypto / CFG80211 | — | mainline (config) | ✅ =y (batch2) |
| AIC8800 wifi (bsp/fdrv) | aic8800_* | out-of-tree | ✅ M5 — wlan0 up, scanned the site AP at −43dBm (modules, wifi/VERIFIED-on-c8a3.md) |
| AIC8800 BT (btlpm) | aic8800_btlpm | out-of-tree | 🔨 module built (6.18 vermagic); HCI bring-up not yet exercised |
| NPU (rknpu, ff660000) | rknpu, ff660000.npu | out-of-tree | 🔨 M6 built, 0 errors/0 warnings, 99 rknpu-prefixed symbols in System.map, &npu {status="okay"} in the dtb — not yet flashed/probed on hardware (build-only session; see npu/PORT-PROGRESS.md) |
| RGA 2D (rga2) | rga2 | ported (vendor char-dev) | ✅ /dev/rga, hw 3.3.87975 |
| I2S audio (i2s-tdm) | i2s | rv1126 fallback (=y) | ✅ cpu DAI registers (part of the card below) |
| Audio codec (acodec) | rockchip,rv1106-codec | ported (rv1106_codec.c) | ✅ card rv1106-acodec, pcmC0D0p/c (audio/); audible test @ bench |
| HPMCU mailbox (ff5c0000) | rockchip,rv1106-mailbox | rk3368 fallback +rv1106 num_chans=1 | ✅ A7<->SCR1 round-trip, 5/5 exact (mailbox/VERIFIED.md) |
| PVTM (core+pmu ring-osc) | rockchip,rv1106-*-pvtm | ported (vendor, no mainline) | ✅ both probe; debugfs reads (pvtm/) |
| FIQ debugger (ttyFIQ0) | fiq_glue | rockchip | ⬜ optional (we use ttyS2) |
Legend: ✅ verified on hardware · 🔨 built, not yet verified · ⬜ not started.