Files
bfe-core1106-sdk/kernel/rv1106-enablement/OVERNIGHT-RESULTS.md
T
BFE EngineeringandClaude Opus 4.8 aa25577095 kernel/rv1106: overnight run results + final capabilities ledger
Six drivers verified on hardware this run (wifi, TRNG, OTP, GMAC, SARADC,
audio). Final honest ledger: mailbox (fallback-binds, no client), crypto-v3
(CPU crypto covers), NPU (no open userspace), pvtm (DVFS-only) all deferred
with reasons — no unexplored capability gap. Morning bench tasks documented
(display connector, audible audio, wifi boot-time auto-load).

OVERNIGHT-RESULTS.md added.

Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_017wB8KB3MMQztRDXCMCkPrf
2026-08-25 01:24:40 -06:00

44 lines
2.4 KiB
Markdown
Raw Blame History

This file contains ambiguous Unicode characters
This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.
# Overnight kernel-enablement run — results (2026-08-24 night → 08-25)
Goal ([maintainer]): port/enable **every** remaining RV1106 hardware capability on the
self-built Linux 6.18.46, open-source-first, verify on hardware, so the display's
last mile can start in the morning. Runs on warden-c8a3 (`_b` slot = our 6.18).
## ✅ Verified on hardware this run
| Driver | Evidence |
|---|---|
| **AIC8800 wifi** (M5) | wlan0 up ([device-mac]), `iw scan` found the site AP 43 dBm + others. Modules (built-in deadlocks the two-stage SDIO bring-up). |
| **TRNG** | `/dev/hwrng`, `rng_current=rockchip-rng`, real entropy. |
| **OTP/nvmem** | `rockchip-otp0` reads chip id ("MR1"). |
| **GMAC** (wired eth) | `eth0: Link is Up - 100 Mbps/Full`. |
| **SARADC** | `iio:device0` reads 2 channels (adc-keys). |
| **Audio** | card `rv1106-acodec`, `/dev/snd/pcmC0D0p`+`pcmC0D0c`. Audible test → bench. |
(These join the earlier-verified set: clk, pinctrl, GIC, timer, DMA, eMMC, uart×3,
i2c, wdt, RTC, tsadc, RGA, USB host, PWM backlight. VOP display binds — connector
is the morning task.)
## Cross-cutting fixes made this run
- **XZ compression** (`CONFIG_KERNEL_XZ`): the growing kernel overran U-Boot's
DTB-at-0xc00000 load boundary (`Sysmem Error`, FLARE-AB fell to _a). zImage
12.1→8.3 MB, ~4 MB headroom. See `kernel-618-btest-cycle` memory + wifi doc.
- **Module vs built-in**: wifi must be modules (SDIO two-stage bring-up races the
mmc probe when built-in — sequential initcall deadlock). Audio/GMAC/etc. are
built-in and fine.
- Hardened the c8a3 `_b`-test → `_a`-recover cycle (compact-hex AVB serial write +
readback while stable; Pi golden-env fallback for bootcount→loader).
## Not done — deferred with reasons (see CAPABILITIES-AUDIT.md)
mailbox (binds via rk3368 fallback but no client to exercise), crypto-v3 (CPU
crypto extensions already cover it; 100 KB port), NPU (no open userspace),
pvtm (DVFS-only). Camera/ISP/SPI: no hardware. **No unexplored capability gap.**
## Morning (needs [maintainer] at the bench)
1. **Display connector** — VOP binds + DRM card0 + panel probes, but no connector
link yet; needs eyes on the panel (pixels can't be verified over serial).
2. **Audible audio**`speaker-test`/`aplay` through the acodec.
3. Wifi **boot-time auto-load** (modules currently insmod'd by hand) — a loader
that inserts aic8800_bsp→fdrv(→btlpm) from the rootfs.
Provenance: every ported driver is GPL-2.0 kernel source (`PROVENANCE.md`).